How to Make a Guitar Stay in Tune ?
How to Make a Guitar Stay in Tune – For a professional who plays the guitar often or maybe every day, tuning the guitar or keeping it in tune is certainly something normal and easy. But for beginners, this is certainly a bit difficult to do, because they haven’t yet honed their pitch sensitivity, so it’s difficult to find the tone. If you want to tune, you can use an application like Guitar Tuner. If you want to keep the guitar in tune, how do you do it? Check the explanation in the following article.
Prepared Tools
Before starting, prepare the tools below:
- Guitar strings
- String winder
- Tuner
- Scissors
- Tuning lubricant
- 10 mm wrench
- PH1 screwdriver
Step by Step to Keep Guitar in Tune
Step 1
Come on, first check whether the guitar tuning is correct. If the string is too high, you have to bend it so that the sound produced is good. At the 12th fret, the string height should usually be 2.2 mm for the sixth string and 1.5 mm for the first string. Apart from that, the intonation and height of the pickup also need to be adjusted properly.
Another important thing is to wind the strings correctly. Many guitar doctors don’t like playing guitar with bad strings. The way to get the strings wound properly is to let the strings pass through the bridge and press down on the 12th fret, making sure each penny has the same number of coils. And to tie the string neatly without having to knot it, you can cut off the excess part of the string, and wrap the loose end under the first loop. Then, bend the loose end up over the initial loop, and finish by looping the string under the initial loop. Finally, reset the tone and repeat the steps.
Step 2
Next, you need to stretch the strings that were installed earlier. First, tune the guitar, then stretch each string one by one. Note how many notes go down. When the string is stable enough, repeat the stretching process until the string no longer drops in pitch. Check that the tuners on the headstock are installed correctly, and make sure the tuner nuts on the front are tightened about 10mm. But be careful, don’t overdo it, because this nut can be weak.
On the back of the headstock, many tuners are equipped with a small screw that helps secure it to the headstock. Make sure these screws are working properly. Don’t overtighten it, as it could cause damage. If the screw turns freely, you will need to repair the hole and re-drill.
You May Also Like:
Step 3
When you use a tremolo or bend the strings, the strings will rub slightly at each contact point on your guitar, and for optimal results, you need to minimize these openings. One way is to lubricate the nut slots using a special lubricant product. Make sure the bridge saddle is also lubricated,. Apart from that, the string holder also needs lubricant. If something is not maintained properly, it can affect the performance of the guitar.
It is also important to ensure that the two parts of the guitar, namely the neck and body, are firmly connected. A solid connection is necessary not only to maintain stable guitar tuning but also to maintain overall sound quality and performance.
If you have done all the steps of How to Make a Guitar Stay in Tune above, you are guaranteed that your guitar will always sound good and stay in tune. Don’t forget to try.
